TIPS FOR GETTING THE MOST OUT OF YOUR CROWN TOUCHPAD
Make sure there are no underlying air bubbles.
Throughly Clean the stick beforehand, any grease or particulates will prevent the TouchPad from sticking correctly.
A fresh stick will make the TouchPad last longer.
Continually playing on surfaces other than water-based astroturf will greatly reduce the longevity of the TouchPad.
Make sure all edges are firmly secured to the surface of the stick.
Can be cut using a sharp knife or scissors for a customised fit.
Open up your Crown TouchPad, before beginning to apply, throughly clean the face of the stick with water, then completely dry.
Peel away non-adhesive 3M side from clear Crown TouchPad.
Before applying, line up the hook with the edge of the TouchPad, leaving a 2-3mm gap between the tape and the edge of the stick.
By pushing with your thumb, smooth on the hook of the TouchPad from the centre to the outside.
Ensure that there are no air bubbles underneath. If there are continue to push from the centre outward.
Slowly lower the rest of the TouchPad onto the stick.
Again leave a 2-3mm gap between the TouchPad and edge of the stick.
Again leave a 2-3mm gap between the TouchPad and edge of the stick.
Smooth down the inside edge.
Your TouchPad is now applied!
